M402b MiniPortrait Camera Repair Manual
Disassembly/Assembly
20
Shutter Cocking Lever
(Figure 2-7)
Removal
1. Remove the front cover assembly (Figure 2-1).
2. Using a pair of small needle nose pliers, gently remove the clip and washer that
secure the return spring to the plastic post at the lower end of the shutter cocking
lever.
If necessary, use an Xacto knife to cut away the top of the plastic post so that
the clip and washer can be removed easily.
Note:
While removing the shutter cocking lever be careful not to misalign
the shutter and the diaphragm plates.
If the shutter and the diaphragm plates are misaligned during the
removal of the shutter cocking lever, refer to the Shutter and
Diaphragm Plate assembly/disassembly procedure to properly
realign (see page 24).
3. Remove the shutter cocking lever from the left shutter cocking guide being careful not to
misalign the shutter and the diaphragm plates.
Figure 2-7. Replacing shutter cocking lever
Shutter Plate
Assembly
Shutter
Cocking Lever
Plastic Post
Camera Body
Left Shutter
Cocking Guide
Square
Cocking Slot
Right Shutter
Cocking Guide
Aperture
Drive Gear
