- 21 -
Channel FineTune Operation
You can adjust the current channel by using the TV FINETUNE feature to adjust the
TV’s image and audio quality to finally get the best viewing.
•
Panel button mode:
In the TV status, press the Menu button continuously. The screen will display
[Fine Tune Channel], press the CH
button continuously until the screen displays
[Fine Tune Channel >>>], press the CH
button continuously. The screen will
display [Fine Tune Channel <<<].
•
Remote control mode:
In the TV status, press the WIFI menu button. The screen will display [Fine Tune
Channel], press the CH+ continuously. The screen will display[Fine Tune
Channel >>>], press the CH- continuously, the screen will display [Fine Tune
Channel <<< ].
BITRATE Operation
Bitrate setup is helpful for image quality and transmission distance. High bitrate: image
is more clearly suitable for near distance viewing. Low bitrate: the wireless transmission
distance is further, suitable for far distance viewing. Please set the bitrate to low, if the
quality of image transmission is bad.
•
Panel button mode:
In the TV status, press the Menu button continuously. Tthe screen will display
[MPEG Bitrate High], press the CH
/
button, the screen will display [MPEG
Bitrate High], [MPEG Bitrate Mid], [MPEG Bitrate Low]. Press the INPUT/ENT
button to confirm.
•
Remote control mode:
In TV status, press the WIFI menu button. The screen will display [MPEG Bitrate
High], press the CH+ or CH- button, the screen will display [MPEG Bitrate High],
[MPEG Bitrate Mid], [MPEG Bitrate Low]. Press ENT button to confirm.
Scan for signal
You can rescan the signal through the following operation:
•
Panel button mode:
In the TV status, press the Menu button continuously, the screen will display [Scan
For Signals OFF], press the CH
/
button to select [Scan For Signals ON], press
the INPUT/ENT button to start the signal scanning.
•
Remote control mode:
In the TV status, press the WIFI menu button continuously, the screen will display
[Scan For Signals OFF] item, then press the CH+, or CH- button to select [Scan
For Signals ON] item, press the ENT button to start the signal scanning.
Using the Wireless
System
