background image

Photo Booth is designed for indoor and personal use only. It must not be installed permanently outdoors. 

The following conditions must be avoided.
1. Direct exposure to sunlight, high humidity, direct water contact, dust, high heat, or extreme cold.

2. Vibration. Photo Booth must be installed on a level surface. Do not install in an area such that the Photo Booth would present an obstacle in case of an emergency 

    (i.e., near fire equipment or emergency exits).

WARNING: Tastemakers Asia Limited assumes no liability for improper installation or excessive loads placed on screws or bracket. 
This wall anchor is not a substitute for proper adult supervision.

IMPORTANT SAFETY INSTRUCTIONS

INSTALLATION

READ BEFORE USING THE PHOTO BOOTH

SAFETY PRECAUTIONS

The following symbols are used in labels on the Photo Booth to draw attention to potentially hazardous situations: 

WARNING : Failure to avoid the risk may result in death or serious injury.

Electrical Shock Hazard. Disconnect power before removing cover. 

Should only be done by a qualified technician.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this 

device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed 

and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the 

user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet that Is on a circuit different from the receiver.

• Consult the dealer or an experienced radio / TV technician for help.

FCC STATEMENT

WARNING :  To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture

.

1. Please read and comprehend all warnings stated in this manual.

2. Do not get product wet when cleaning.

3. The AC/DC adapter and apparatus shall not be exposed to dripping or splashing and that no object filled with liquids, such as vases, shall be placed on apparatus.

    The AC/DC adapter is used as disconnect device.The AC/DC adapter of apparatus should not be obstructed OR should be easily accessed during intended used. 

    To completely disconnect the power input, the AC/DC adapter of the apparatus shall be disconnected from the main power outlet.

4. If appliance is provided with protective earth terminal, it should be connected to main outlet with a protective earth connection.

5. Minimum distances 10 cm / 3.94 inches around the apparatus for sufficient ventilation.

6. The ventilation should not be impeded by covering the ventilation openings with items such as newspaper, table-cloths, curtains etc.

7. No naked flame sources such as lighted candles should be placed on the apparatus.

8. The apparatus should only be used in moderate climates.

1.   Read these Instructions.

2.   Keep these Instructions.

3.   Heed all Warnings.

4.   Follow all Instructions.

5.   Do not use this apparatus near water.

6.   Clean only with a dry cloth.

7.   Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8.   Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9.   Do not defeat the safety purpose of the polarized or grounding - type plug. A polarized plug has two blades with one wider than the other. A grounding type plug 

      has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. When the provided plug does not fit into your outlet, 

      consult an electrician for replacement of the obsolete outlet. 

10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Unplug this apparatus during lightning storms or when unused for long periods of time.

13. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is 

      damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has 

      been dropped.

14. The equipment shall be used at working ambient temperature 32° - 95°F (0° - 35°C).

WARNING

To ensure safe operation of the product, be sure to read this User Manual before use.

Keep this User Manual in a safe place for easy reference when needed.

WARNING

This product can expose you to chemicals including Styrene and Benzene, which are known to the State of California to cause birth defects or other reproductive harm. 

For more information go to www.P65Warnings.ca.gov

Summary of Contents for BI65-120400-E2





















Reviews:

Related manuals for BI65-120400-E2