Polaroid Originals OneStep+, User Manual

Page: 25 / 160

User Manual
25
EU Declaration of Conformity
Hereby, Impossible B.V. declares that the
analog instant camera is in
compliance with the essential requirements
of the Electromagnetic Compatibility Direc-
tive (2014/30/EU), Low Voltage Directive
(2014/35/EU) and RoHs Directive (2011/65/
EU) and other relevant provisions, when
used for its intended purpose.
FCC Compliance Statement
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
Caution The user is cautioned that changes
or modifications not expressly approved
by the party responsible for compliance
could void the user’s authority to operate
the equipment. This equipment must not be
co-located or operated in conjunction with
any other antenna or transmitter.
Note his equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be deter-
mined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
This equipment complies with fcc radiation
exposure limits set forth for an uncontrolled
environment. End user must follow the
specific operating instructions for satisfying
rf exposure compliance.
Industry Canada (IC)
This device complies with part 15 of the FCC
Rule and Industry Canada license–exempt
RSS standard(s). Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may
cause undesired operation. Le présent
appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio
exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes: (1)
l’appareil ne doit pas produire de brouillage,
et (2) l’utilisateur d’appareil doit accepter
tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en comprom-
ettre le fonctionnement.
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless
Device is below the Industry Canada (IC)
radio frequency exposure limits. The Wireless
Device should be used in such a manner such
that the potential for human contact during
normal operation is minimized.
This device has also been evaluated and shown
compliant with the IC RF Exposure limits under
portable exposure conditions. (antennas are
less than 20 cm of a person’s body).
The symbol means that according to
local laws and regulations your product
should be disposed of separately
from household waste. When this product
reaches its end of life, take it to a collection
point designated by local authorities. Some
collection points accept products for free.
The separate collection and recycling of
your product at the time of disposal will help
conserve natural resources and ensure that it
is recycled in a manner that protects human
health and the environment.