Polaris trail boss 325, Owner'S Manual

Page: 104 / 189

93
BATTERY
Battery Removal
1. Disconnect hold down straps holding the electrical box and bat-
tery in position and remove battery cover.
2. Remove the battery vent tube from the battery.
3. Disconnect the black (negative) battery cable first.
4. Disconnect the red (positive) battery cable next.
5. Lift the battery out of the ATV, being careful not to tip it sideways
and spill electrolyte.
Battery Installation and Connections
Battery terminals and connections should be kept free of corro-
sion.
If cleaning is necessary, remove the corrosion with a stiff wire
brush. Wash with a solution of one tablespoon baking soda and
one cup water. Rinse well with tap water and dry off with clean
rags. Coat the terminals with dielectric grease or petroleum jelly.
Be careful not to allow cleaning solution or tap water into the bat-
tery.
If electrolyte spills, immediately wash it off with a solution of
one tablespoon baking soda and one cup water to prevent
damage to the ATV.
To avoid the possibility of explosion, always connect battery
cables in the order specified. Red (positive) cable first; black
(negative) cable last. An exploding battery can cause serious
injury or death.