Polaris RZR XP 4 TURBO S VELOCITY 2019, Owner'S Manual For Maintenance And Safety

Page: 146 / 222

6. Clean the filter sealing surface on the engine crankcase with a clean rag and
ensure the original oil filter o-ring is not stuck to the crankcase.
WARNING
Do not use a hose/pressure washer to clean up spilled oil on a vehicle. This
may spread oil into surfaces that may get hot which may lead to a fire.
7. Lubricate the o-ring on the new oil filter with a film of clean engine oil. Check
to make sure the o-ring is in good condition. Tighten to specification (Turn by
hand until filter O-ring contacts sealing surface, then turn an additional 3/4
turn.)
8. Inspect the sealing washer on the drain plug for burrs or nicks. Replace the
washer if it is damaged.
9. Reinstall the engine crankcase drain plug. Torque drain plug to specification
[12 ft-lbs (16 Nm)].
10. Remove the cargo box access panel. Add engine oil through the oil fill cap
w
located on top of the engine valve cover.
11. Fill the engine to the recommended specification.
12. Start engine and allow it to idle for 30 seconds.
13. Stop the engine and inspect for leaks. Wait at least 15 seconds before
removing the oil dipstick.
144
MAINTENANCE