Polaris RZR 200 EFI 2021, Owner'S Manual

Page: 137 / 172

TROUBLESHOOTING
DRIVE BELT WEAR/BURN
POSSIBLE CAUSE SOLUTION
Driving at low RPM or ground
speed Drive at a higher speed.
Insufficient warm-up at low
ambient tempera- tures Warm the engine at least 5 minutes. With the transmission in
neutral, apply small amount of throttle in short bursts, 5 to 7
times. The belt will become more flexible and prevent belt
burning.
Slow/easy clutch engage-
ment Use the throttle quickly and effectively.
Belt slippage from water or
snow ingestion into the CVT
system Dry out the CVT. Prevent water from entering the CVT inlet and
outlet ducts. See page 102. Inspect clutch seals for damage if
repeated leaking occurs.
Clutch malfunction Your Polaris dealer can assist.
Poor engine performance Check for fouled plug or foreign material in gas tank or fuel lines.
Your Polaris dealer can assist.
Wrong or missing belt Install the recommended belt.
Improper break-in Always break in a new belt and/or clutch.
ENGINE DOESN’T TURN OVER
POSSIBLE CAUSE SOLUTION
Low battery voltage Recharge the battery to 12.8 VDC.
Loose battery connections Check all connections and tighten.
Loose solenoid connections Check all connections and tighten.
ENGINE TURNS OVER, FAILS TO START
POSSIBLE CAUSE SOLUTION
Out of fuel Refuel.
Water is present in fuel Drain the fuel system and refuel.
Old or non-recommended fuel Replace with fresh recommended fuel.
Fouled or defective spark plug Inspect plug and replace if necessary.
No spark to spark plug Inspect plug and replace if necessary.
135
TROUBLESHOOTING