Polaris RANGER XP 1000 2020, Owner'S Manual

Page: 40 / 156

SEAT BELT INSPECTION
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate must slide
smoothly into the buckle. A click indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to make sure it
releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage,
including cuts, wear, fraying or stiffness. If any damage is found, or if the seat
belt does not operate properly, have the seat belt system checked and/or
replaced by an authorized dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap
and water. Do not use bleach, dye or household detergents. Rinse the entire
length of the belt webbing. Use a garden hose to flush out the retractor and
latch housings regularly.
SEAT AND STORAGE COMPARTMENTS
The electrical compartment is located under the center rear-most seat. Never
use this area for storage. Storage compartments are located under all other
seats. Remove the storage bin under the right rear-most passenger seat to
access the battery.
Always make sure all seats are properly installed before operating. Push down
firmly on the rear of each seat until the latch pins are fully seated into the
grommets.
DRIVER’S SEAT
To access the storage area under the driver’s seat, reach behind the driver’s
seat and pull up on the latch. Roll the bottom of the seat forward toward steering
wheel.
PASSENGER’S SEAT
To access the storage area under the passenger seat, lift up on the front of the
passenger seat and raise it to the upright position.
38
FEATURES AND CONTROLS
Downloaded from ManualsNet.com search engine