46
6.
Place the holder and filter in the coffee machine. To do this, insert it from the bottom up into the holder slot
on the coffee machine's body so that the handle of the filter holder is located under the mark and fix it by
turning the holder by the handle to the right by 40-45 degrees up to the mark (You should not make a
significant effort!)
7.
Place the cup under the filter holder nozzles on the tray grid and adjust the cappuccino nozzle to drain the
water into the cup.
8.
Turn on the power of the coffee machine by pressing the ON/OFF button once and the symbols on the front
panel of the coffee machine will start flashing. The coffee machine will start heating up.
9.
Complete the "Single cappuccino" cooking program by pressing the FROTH button once. Follow these steps
until the tank runs out of water.
10.
After all the water has drained off, rinse the containers, filter and holder thoroughly. Attention!
During the first use or after a long break in use, the pump may be noisy. This is normal, the
noise will decrease in about 20 seconds after the main line is filled with water.
Preliminary heating
To make a good cup of hot coffee we recommend preheating of the coffee maker with the filter installed.
This eliminates the influence of cold parts of the coffee maker on the coffee brewing.
1.
Fill the tank with water (the water level must not exceed the "max" mark) and install it in the coffee
machine's body.
2.
Fill the tank with water (the water level must not exceed the "max" mark) and 13 install it in the coffee
machine's body.
3.
Install the holder with the filter in the coffee maker according to paragraph 6 of the section "Preparation for
use".
4.
Place a suitable cup on the tray grid.
5.
Insert the power plug into the power outlet.
6.
Turn on the power of the coffee machine by pressing the ON/OFF button once and the light symbols on the
front panel of the coffee machine will flash 3 times with an audible signal. The coffee machine will start
heating up.
7.
Wait until the light symbols stop flashing and press the FROTH button once. After the process is complete
the symbols will stop flashing again. Preheating is now complete. Before you put the coffee in wipe the filter
dry.
Attention!
If you press the symbol before it stops flashing the coffee machine will make a warning sound
meaning that the desired temperature has not been reached and you should wait for the
symbols to stop flashing.
The auto-off function of the coffee machine is triggered automatically 25-30 minutes after switching on
if no actions are performed with it. At the same time, all light symbols are extinguished. To resume
operation it is enough to remove/put the milk container or turn off the device by pressing the on/off
button and turn it on again with the same button at least 5 seconds after switching off.
The coffee machine will start heating up or it will be ready to make coffee.
Choosing the cup size – Fig/2
Start making coffee
1.
The pre-prepared and warmed coffee machine is ready for use and the indicator lights are always
on.
2.
Remove the filter holder from the socket on the body of the coffee machine (if it is installed) by
turning it from the position by the handle to the left at about a 45-degree angle and lowering it down.
Wipe the filter dry if necessary and install it in the holder. Fill the filter with ground coffee using a