7.14
9929375 R02 - 2016-2019
GENERAL
/
GENERAL 4
Service Manual
© Copyright Polaris Industries Inc.
PROPSHAFT REMOVAL - GENERAL 4
(2017)
1. Raise and support the vehicle.
WARNING
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this
procedure. Always wear eye protection.
2. Remove skid plate from the vehicle. Refer to
procedure.
3. Locate the prop shaft roll pin and use the Roll Pin
Removal Tool (
2872608
) to remove the roll pin.
Discard roll pin. Push the front prop shaft rearward to
remove it from the front gearcase input shaft.
4. Slide the front propshaft
q
off the center propshaft
w
and remove it from the vehicle.
CAUTION
Use care not to damage brake lines when removing
propshafts.
5. Remove the fasteners retaining the support bearing
for the center propshaft to the frame.
6. Slide the center propshaft off the rear propshaft and
remove it from the vehicle.
7. Remove the fasteners retaining the rear support
bearing cover to the frame.
NOTICE
Not the orientation of the coolant line clip for
installation.
8. Slide the rear prop shaft forward to remove it from the
transmission output shaft.