Polaris 6X6, Manual

Page: 169 / 292

FINAL DRIVE
7.11
clamp.
CV Joint Grease - 30g PN 1350046
CV Boot Clamp Pliers:
Earless Type
8700226
Boot Replacement requires 30g
Boot replacement with complete CV
joint cleaning requires an additional
30g. (Total 60g)
CV Joint Grease - 30g PN 1350046
CV Boot Clamp Pliers:
Earless Type
8700226
FRONT SHAFT
Joint Capacity
30 Grams
Boot Capacity
30 Grams
Front outboard joint capacity: 30g if boot
is replaced only. Another 30g (60g total) if
joint is cleaned.
(4x4 & 6x6)
FRONT PROP SHAFT
REMOVAL (4X4 & 6X6)
1. Elevate front end and safely support machine
under footrest / frame area.
CAUTION: Serious injury may result if machine tips
or falls. Be sure machine is secure before beginning
this service procedure. Wear eye protection when
removing bearings and seals.
2. Remove wheel nuts and wheel.
3. Remove cotter pin and nut from lower A-arm ball
joint. Remove lower A-arm from ball joint. (See
below)
4. Use the Roll Pin Removal Tool (PN 2872608) , to
remove the roll pin from prop shaft at rear of
housing. Slide prop shaft back and away from
front housing. Pull sharply forward to remove
from transmission shaft.
NOTE: The roll pin can also be accessed through the
hole in the skid plate shown in the photo below.