Polaris 6X6, Manual, Page: 36 / 292

GENERAL INFORMATION
2.24
AIR INTAKE INSPECTION
Foam
Engine Intake
Air Box
Air Baffling
Box
Duct
1. Lift the hood.
2. Inspect the foam inserts in the air baffle boxes. If
the foam inserts are dirty, clean the foam with a
high flash point solvent, followed by hot soapy
water.
3. Rinse and dry the foam thoroughly.
4. Inspect the foam for tears or damage. Replace if
necessary.
5. Reinstall the foam inserts into the air baffle boxes.
FLYWHEEL HOUSING
S
Drain the housing periodically to remove moisture.
S
Drain the flywheel housing after
operating the vehicle in very wet
conditions. This should also be done
before storing the vehicle. The drain
screw is located at the bottom of the
flywheel housing. Remove the plug.
Reinstall the plug once housing has
been drained.
S
After travelling in wet areas the
engine housing and starter should
always be drained completely by
removing the housing.
S
Do not open the crankcase drain
unless the engine has ingested
water. Some engine oil will be lost if
crankcase drain is opened.
Plug
Gasket