119
MAINTENANCE
Steering System
n
Ski Skags
Some models have one skag, others may have dual skags. Check skags
before each use of the snowmobile to ensure positive steering character-
istics. Skags must be replaced when worn to half their original diameter.
NOTE:
Carbide skags must be replaced if any abnormal wear or chip-
ping is found.
Skag Replacement
1. Raise and support the front of
the machine so the skis are
approximately 6
I
(15.2 cm)
from the ground.
2. Remove the attaching nuts
and pry the skag downward.
3. Remove the front end of the
skag.
4. Remove the rear end of the
skag.
5. Reverse the steps to install a
skag.
WARNING
Worn skis and/or skags will adversely affect handling. Loss of vehicle control
may result, causing serious injury or death.
See your dealer's studding chart for recommended skags. If you install
longer or more aggressive carbide skags than the original equipment, it may
also be necessary to add track studs to maintain proper vehicle control while
turning on hard-packed snow or ice.
Summary of Contents for 600 Fusion
Page 1: ......
Page 2: ......
Page 142: ...139 MAINTENANCE LOG DATE MILES KM TECHNICIAN SERVICE PERFORMED COMMENTS...
