Instr 9927572
Rev 01 2016-11
Page 4 of 4
e. After exiting forward end of center console,
route harnesses up forward side of firewall to
under-hood compartment.
RZR
®
900, RZR
®
S 900, RZR
®
S 1000
a. Route harnesses down RH B-pillar (4 Seat: C-
Pillar), through gap between base of pillar and
body panel into wheel well, then down along
vehicle frame (behind rear close-off panel).
b. Route harnesses inboard to center console,
then forward through center console following
battery connection cables (sold separately).
c. After exiting forward end of center console,
route harnesses up forward side of firewall to
under-hood compartment.
6. Connect harnesses to terminal block and audio
source component.
a. Connect power harness
w
ring terminals to
terminal block:
•
RED
harness wire: To post with existing RED
battery connection cable (unswitched 12V
POS); post may be identified as “BAT”
•
BLACK
harness wire: To post with existing
BLACK battery connection cable (12V NEG);
post may be identified as “GND”
b. Route 4–pin connector on signal harness
q
and blue wire bullet connector on power
harness
w
from under-hood compartment
rearward through firewall grommet into upper
dash compartment, then join to corresponding
connectors on audio source component. See
Kit Contents for detail.
7. Secure signal harness
q
and power harness
w
to
battery connection cables in center console, and to
remainder of vehicle as shown in Step 5, using
cable ties
e
.
Prevent harness contact with hot components,
sharp edges, or moving parts. Coil and secure
excess harness length in upper dash
compartment.
8. Restore access. If other electrical harnesses were
disconnected in Step 3c. then reconnect them
now.
9. Reconnect black negative (-) cable to battery and
reinstall seat.
FEEDBACK FORM
A feedback form has been created for the installer to provide any comments, questions
or concerns about the installation instructions. The form is viewable on mobile devices
by scanning the QR code or by clicking
if viewing on a PC.
FEEDBACK FORM
