Instr 9927572
Rev 01 2016-11
Page 3 of 4
4. Connect signal harness
q
and power harness
w
to master audio pod (audio pods sold separately).
a. Join small 4–pin connector on signal harness
q
to mating 4–pin connector on audio pod.
b. Join large 4–pin connector on power harness
w
to mating 4–pin connector on audio pod.
5. Route signal harness
q
and power harness
w
.
NOTE
Harnesses shown in final secured configuration.
RZR XP
®
1000, RZR XP
®
TURBO
a. Route harnesses down RH C-pillar (4 Seat: D-
Pillar), then through gap between base of pillar
and body panel into wheel well.
NOTE
Vehicle shown with optional Subwoofer Kit PN
2882063 (sold separately).
b. Route harnesses forward along vehicle frame,
in front of air intake tube, then outboard along
frame (behind rear close-off panel).
c. Route harnesses down along vehicle frame
until below rear stabilizer bar attach points.
d. Route harnesses inboard to center console,
then forward through center console following
battery connection cables (sold separately).
NOTE
Harnesses will be secured to shift cable
G
using
cable tie
e
(see Step 7).
