Instr 9927572
Rev 01 2016-11
Page 2 of 4
INSTALLATION INSTRUCTIONS
1. Shift vehicle transmission into “PARK”. Turn key to
“OFF” position and remove from vehicle.
2. Remove driver’s (or left rear passenger) seat and
disconnect black negative (-) cable from battery.
3. Gain Access.
NOTE
RZR XP
®
1000 shown; other vehicles similar.
a. Remove hood.
b. Remove windshield (if installed).
c. Remove two screws
A
securing front of upper
dash panel, then carefully pull panel rearward,
disengaging seven retaining clips
B
as shown.
If necessary for access, label and disconnect
other electrical harnesses from control panel.
d. Remove center floor console.
TWO PASSENGER VEHICLES
Remove five push pin rivets
C
and two screws
D
as shown. Remove center console, pushing
boots for gear shift and seat belt through
console openings. Retain rivets and screws.
FOUR PASSENGER VEHICLES
i.
Remove five push pin rivets
C
and four
screws
D
from front floor console as
shown. Remove console, pushing boots for
gear shift and seat belt through console
openings. Retain rivets and screws.
ii. Remove four push pin rivets
E
and two
screws
F
from rear floor console as shown.
Remove console, pushing boots for gear
shift and seat belt through console
openings. Retain rivets and screws.
