Polaris 2010 Kingpin, Owner'S Manual

Page: 124 / 167

120
Maintenance
Headlight Aim Inspection
Bullet Headlights: The top edge of the high beam must be 3 inches (7.6
cm) below the height of the headlight housing parting line and centered
straight ahead at 25 feet (7.6 m).
Round Headlights: The top edge of the low beam must be at the same
height as the center of the headlight lens and centered straight ahead at
25 feet (7.6 m).
1. Verify that tire pressure is at specification. See page 110.
2. Verify that rear suspension ride height (preload) is at specification.
Include rider, passenger (if applicable) and cargo when setting
preload. See page 88.
3. Position the motorcycle on a level surface with the headlight 25 feet
(7.6 m) from a wall.
4. With the operator and passenger (if applicable) on board, bring the
motorcycle to the fully upright position.
5. Move the ignition switch to the ON position and switch the
headlamp to high beam. Observe the headlight aim on the wall.
6. Make any necessary adjustments to headlight aim.
25 ft. (7.6 m)
3 in. (7.6 cm)
25 ft. (7.6 m)
Height of headlamp
housing parting line
Height of center
of headlamp lens
Bullet Headlight High Beam
Round Headlight Low Beam