Photocells
For safety reasons, disconnect the power supply before these activities.
Before connection of photocells, remove the conductor (jumper) from between terminals 3 and 4
of the electronic module.
Photocells allow stopping the gate or change of its movement direction in case of an
obstacle detection.
You can mount a set of photocells. Each set of photocells consists of:
•
transmitting photocell (TX),
•
receiving photocell (RX).
▶
Location of photocells
To allow assembly of conductors, locate the
receiving photocell on the post where the drive
equipped with the electronic system is located.
2 8 m
25 cm
max. 20 cm
33
EN
- Assembly and service manual for EASY WAY202
EN
Remote control programming
Accessory wiring
It is recommended to carry out automatic learning of the gate movement course before
connection of accessories (photocells, orange light, etc.)
