Polar Spas AquaKing Additional Instructions Download

Page: 3 / 23

Additional assembly instructions for Polar AquaKing (v. 092009)

Thank you for choosing a product from SpaDealers. Polar AquaKing is a unique wooden spabath
with a plastic inner lining and edging. This makes cleaning easy and protects the wood. When
assembling it is very important to follow the instructions in order to avoid leakages. Please read our
guarantee conditions and what they include.

NOTE!

All wooden parts must be stored at a dry location and be dry during assembly. Never

assemble in the rain or when humidity is high.

These additional assembly instructions contain important descriptions, which refer to the picture
numbers shown in the graphic instructions. This text refers to AquaKing Jets. The assembly of
AquaKing Standard follows the same procedure, but the holes and parts needed for connecting the
jet massage are not included.

If you have any queries, please contact us at +358-(0)10-239 5600

or [email protected]

Taping the joint before applying sealant
IMPORTANT!

Before starting to fill the joints, masking tape should be applied according to

recommendations. See pictures

and

. Masking tape needs to be placed outside the pre-

marked line.

Note

where the masking tape starts and ends according to the letters in the pictures.

This is important, because it will be easier to remove the tape when the sealing procedure has
finished. Otherwise, there is a risk of not getting a good final finish and might cause problems later.

NOTE!

Study the details in the pictures, for example the folding of the first masking tape, picture

. The reason for this is the fact that you need something to grip when removing the tape. Check

additional instruction “Mask properly”.

Sealing groove and nozzles for sealant

Grooves have been made in the benches and side parts in order to guarantee the best possible fit.
There are also grooves made for the sealant. Pictures

and

. The assembly tools contain a nozzle

for the black sealing compound which is used to fill the cut outs and grooves.
VERY IMPORTANT! Fill the grooves with a bit more sealing compound than necessary, just that
it comes into contact with the other surface by pressing it down, see picture

. However, be

careful that you

do not use too much

of it, because it can get quite difficult to press the surfaces

against each other.

Assembly of seating area

The seating area is assembled so that 3 benches are assembled first, picture

. Then assemble the

other 3 benches and put both sets of benches facing each other, picture

. Assemble on a clean

smooth cardboard surface or similar to avoid scratching the benches. Use the included textile hoop
in order to tighten the seating area. Place the seating area on the level shown in picture

and

tighten carefully. Carefully tap the vertical sides and the benches with a rubber mallet. The arrows
in picture

show the recommended places. Tighten a bit more and repeat tapping gently with the

rubber mallet. Go all the way round and try to tighten the seating area as well as possible. The
theoretical opening between the benches is 1.5 mm divided equally between all the benches. If too
much sealant has been used, it is possible that the seating area won't become tight enough. In such a
situation it can help to tap the benches and let the tightening pressure press the sealant together.
Tighten the angle bar to each seat, picture

9 /8.

Afterwards please assemble the air valves of the bubble system. It is important to apply silicone
beneath the air valves and on top of the threads. Smear the silicone down on the threads using your
finger. The rubber sealing ring should be placed on the backside and not beneath the air valves,
picture