Polar Spas AquaKing, Additional Instructions

Page: 21 / 23

Mask with tape about 1cm below the hot tubs lower edge before
the rim is attached. See steps 36-37 in the main assembly guide
on how to assemble the rim.
When the edge is in plane, mask the edges
on the edge with masking tape and sand the
area with scotch brite as shown in picture 1.
Apply the masking so there is a 1,5mm
space between the rounded edge and the
tape.
1
2
Apply a new layer of tape on top that goes
all the way to the edge.
Apply mass in the joint as shown in picture
3. Spread out the mass with, for instance, a
spatula as shown in picture 4. Check that
the mass covers the whole joint all the way
around so it meets up with the seal that was
made on underside of the edge.
3
4