Figure 1
Figure 2
STEPS FOR CLEANING BLOCK STYLE FOAM AIR FILTER
NOTE: SEE PARTS EXPLOSION ON PAGE 16
1. Before removing the air filter cover, move the choke lever to the choke position.
(Figure 1)
3. Once the latch tabs are released, remove the air filter cover by rotating the cover away from the engine.
(Figure 3)
4. Remove the white plastic cover and the foam filter element
(Figure 4
、
5)
and replace with anew oiled filter, or clean
the original foam filter with warm water and mild soap by following the previous steps for Cleaning Air Filter.
Remember to thoroughly oil the foam filter with 30 or 40 weight motor oil and squeeze out any excess oil.
5. Reinstall the foam filter and white plastic cover, pressing it in place to ensure that the foam is fully seated into its
sealed position.
(Figure 6)
Figure 3
Figure 4
Figure 5
Figure 6
9
2. To remove air filter cover,
(Figure 2)
loosen and remove the bolt on the cover and squeeze the latch tabs on both
sides of the cover.
6. Replace the air filter cover so that it fully snaps into place and is secured by the latch tabs .Screw bolt back into the
hole and tighten snuggly, but do not over tighten Check that the cover is securely attached by pulling slightly on the
cover. If the cover
doesn’t
move when pulled, it is secure.
Summary of Contents for PFPM-5210
Page 15: ...29 15 ...
