h) Put the vest or head cap on or lay the wrap, blanket, seat, or bladder on a flat
surface and then turn the unit on. Water will begin circulating through the vest,
head cap, wrap, blanket, seat, or bladder and back into the cooling reservoir via
the return flow tube. Allow the unit to run several minutes before tightening the
vest, head cap, wrap, blanket, seat, or bladder to the body. This will ensure good
flow through the system and returning into the cooling reservoir. Always ensure
that there is water flowing through the return tube inside the cooling reservoir.
i) Adjust the temperature control to the desired level. Always adjust this control to
ensure there is a flow of water from the water return tube located in the cooling
reservoir.
CAUTION: Always use an insulation barrier (such as a T-shirt) between the body and
the cooling garment or wrap.
j) When the temperature has risen above the desired temperature, refill the
reservoir with ice. (See steps ‘b’ and ‘c’.) Drain excess water back to the fill line.
k) Confirm that water is flowing through the return flow tube at the top of the cooling
reservoir when the system is on.
CAUTION: Never operate the unit without water. This may cause pump failure.
Setting up the Cool Flow® and CoolOR® system with Chiller
Read and follow all Instructions, Cautions and Warnings on this page, the Cool Flow®
and CoolOR®instructions in this manual, the chiller instructions, and the instructions
on the product(s) before operating this system.
a)
CAUTION: Always begin with power supply unplugged.
Do not turn on the system
until all connections are complete and the hose from the cooling reservoir to the
vest, head cap, wrap, blanket, seat, or bladder is free from bends or restrictions,
as this will restrict water flow through the system.
b) Set the Chiller unit on a flat surface with the screen display facing towards you.
c) Set the cooling reservoir to the right of the Chiller, with the tubing inputs located
on the cooling reservoir lid in the back.
d) Open the cooling reservoir and fill with cool clean water to the fill line
(approximately 2-3 quarts).
CAUTION: Never operate the unit without water. This
may cause pump failure.
e) Add two cupfuls of ice to the cooling reservoir water. This will assist the Chiller
during start-up to quickly reach the target water temperature.
f)
Connect the Chiller to the cooling reservoir as shown below. Be sure the tabs on
the couplings are depressed before connecting and that the couplings click when
they lock together.
2
Connect the “out” connector on the chiller
to the “in” connector on the cooling
reservoir. Connect the “in” connector on
the chiller to the “out” connector on the
cooling reservoir.
Cooling reservoir
may be blue or
white depending
on system.
