Pre.setting torque value
Increase torque value
Decrease torque value
Press
Press
2. Set target torque
Note:
The “Unit Selection” is cyclic.
Track mode
Set peak / track mode
Set peak / track mode
Peak hold mode
Communication
Communication
Long press
Press
Press
Press
/Exit)
for selection
3. Peak hold / track mode selection
Note:
Communication is for calibration of torque wrench.
Please contact your local dealer for information.
TRACK MODE OPERATION
((((((((
))))))))
((((((( )))))))
((…((… …))…)) ((…((… …)) …))
START
*Note 1
*Note 2
*Note 3
(System initial)
Setting target torque
Current torque value
Current torque value
Green LED
Reach 90% of target torque
Red LED
Approached target torque
Buzzer
Buzzer
Reach 90% of target torque
Reach target torque
Apply torque
Note:
1.
1. If
is appeared, that means this
wrench has ever been applied more than
110% of torque of the spec.
2. When 90% of the target torque is reached, the
green LED will begin to flash and the alarm tone will
beep intermittently.
3. When 99.5% of the target torque has been reached,
the alarm will change to a steady tone and the green
LED will stop flashing and stay on. The red LED will also
illuminate.
All manuals and user guides at all-guides.com
