- 9 -
1200_GB-WEISTEANBAU-3752
SNAP CONNECTOR
GB
Pay particular attention before initial
attachment to Tractor!
Note!
For front lifting gear with double-action
hydraulic cycle (danger of damage)!
Remedy:
- Switch control valve to single-action
- Convert front lifting gear to single-action function
(bypass line) through a specialist work shop
• When the mower is attached to the tractor,
the the hydraulic control (ST) must not be
set at „Lower“.
• Immediately after such an operating error,
reset the adjustable plate (P1). Replace
damaged parts beforehand.
The following could happen after an operating error:
- the position of the plate (P1) has changed in the slot;
the gap to the locking hook (V) is therefore too great,
- the locking hook (V) breaks,
- both levers on the load relieving unit become
damaged.
- The limiting chains can snap.
Reset the adjustable plate (P1)
1. Loosen nut (SK) enough to allow position of plate (P1)
to be changed using adjusting screw (ST).
2. Couple the mower to the tractor´s lifting gear
3. Position the adjustable plate (P1) so that the locking
hook (V) can still be unlatched.The gap to the hook
should be as narrow as possible.
4. Uncouple the mower from the tractor´s lifting gear.
5. Tighten screws (SK) to
65 Nm
.
ST-24-11-2003
Beware!
The following
danger source
exists with double
action front
lifting devices
on tractors: The
maximum mower
unit lowering
depth is set with
limiting chains.
If the lifting gear
exceeds the maxi-
mum set lowering
depth then load
is placed on the
limiting chains.
This can lead to the
chain or the linch
pin breaking and
danger of injury
exists for persons
standing in the
danger are!
V
P1
ST
SK
