(372) WARTUNG 9600-GB
GB
Maintenance and Service
- 15 -
Cutter blades and blade bolts
Attention!
Regularly check that cutter blades are
tightened firmly!
-
Buckled or damaged cutter blades must not
be used further.
-
Cutter blades worn on one side can be
turned over and installed again.
-
Blade bolts must be replaced when lower
edge is well worn or at a diameter of 15 mm.
-
Cutter blades on a cutter disc should wear out simultaneously (danger
of imbalance).
Otherwise they are to be replaced with new ones (replace in pairs).
Installing cutter blades
Take note!
The arrow on the cutter blade shows the cutter disc's direction of turn.
-
To install, clean back plates from varnish.
Parts:
Screw (51)
Cutter blade (53)
Nut (54)
(STM = 120 Nm).
Cutter bar
Oil level check
-
Put cutter bar in vertical position and wait approx. 5 minutes.
The oil level is correct when the oil comes up to the level
screw
1
(OIL LEVEL).
Topping up (replenishing) oil
-
Under normal operating
conditions, oil is to be replenished
annually.
-
Take out oil filler plug (63) and top
up oil "SAE 90" up to the level
screw
1
.
Changing oil
-
Change oil after the first 50
operating hours or after 300 ha at
the latest.
Quantity:
CAT DISC 33 = 4,3 lt. SAE 90
-
Put cutter bar in vertical position
and wait approx. 5 minutes.
-
Take out oil drain plug (62), let
run out and duly dispose waste
oil.
-
Take out oil filler plug (63) and top
up oil "SAE 90" up to the level
screw
1
.
1) The oil filler plug (63) is also the level screw (OIL LEVEL)
TD 54/91/31
0,5 - 3 mm
V-belt Drive
-
Check V-belt tension often during operation
Adjustment setting
:
0,5 - 3 mm.
Fahrtrichtung
TD 39/96/28
R E
L I
