(372) WARTUNG 9600-GB
GB
Maintenance and Service
- 14 -
Parking in the open
When parking in the open for long
periods of time, clean piston rods
and then coat with grease.
Winter storage
-
Thoroughly clean machine before storage.
-
Put up protection against weather.
-
Change or replenish gear oil.
-
Protect exposed parts from rust.
-
Lubricate all greasing points according to lubrication chart.
Drive shafts
-
Lubricate both drive shafts
every 8 hours of operation.
-
Pull sliding sections apart
and grease well.
Angular gear
-
Change oil after the first 50 operating hours.
Under normal operating conditions, oil is to be replenished annually
(OIL LEVEL).
-
Change oil after 300 ha at the latest.
Quantity:
0,7 lt. SAE 90
FETT
TD49/93/2
Safety points
• Turn engine off when adjustment, service and repair work is to be
done.
• Do not work under the machine without safe support.
• Retighten all screws after the first hours of operation.
General maintenance hints
In order to keep the implement in good condition after long periods of
operation, please observe the following points:
- Tighten all screws after the first hours of
operation.
Check blade screws in particular.
- Observe maintenance hints for angular
gear and cutter bar.
Cleaning of machine parts
Attention! Do not use high-pressure washers for the cleaning of
bearing- and hydraulic parts.
- Danger of rust!
- After cleaning, grease the machine according to the lubrication
chart and carry out a short test run.
- Cleaning with too high pressure may do damage to varnish.
8
h
FETT
