3
transmitter-sensor in water for extended periods of time .
● Avoid vigorous physical activities or bumps. It may cause complete or partial detachment of the sensor, resulting
in unreliable readings.
●Remove the transmitter and sensor when you have to undergo MRI examinations.As it may cause interruptions
to other medical electrical equipment under extreme circumstances. Avoid strong magnetic field. See details in
the Electromagnetic Compatibility (EMC) Statement.
● Place the sensor not less than 5cm from your insulin pump infusion set or injection site.
● Do not misuse CT3 components with components of other systems. Do not connect your CT3 to other devices
or networks. Refer to manufacturer’s declaration of sensor compatibility.
● Used sensors should be handled according to local regulations for disposal of blood-contacting components to
avoid cross-infection.
● The transmitter, charger and power adapter are electronic devices. Do not wash with water. Do not use them in
humid environment or in strong electromagnetic field.
● Medical devices that do not comply with IEC 60601-1 standard should not be connected to the system.
● Do not let children have access to your CT3 without adult supervision. Do not swallow the small components
that may pose a choking hazard.
Note
● Read the User Manual before you use your CT3 real time continuous glucose monitoring (rtCGM) system. If you
have any questions, please contact HCP or our customer service.
● The transmitter must be fully charged before every use.
● Protect the sensor from coming off the skin. A few people may have skin conditions that tend to cause premature
peeling off of the adhesive, resulting in unreliable monitoring. Use an additional medical adhesive to protect the
sensor when necessary.
● Avoid excessive sweating as it may cause sensor failure. Poor contact, sweating and water ingress may lead to
abnormal readings. Remove the sensor if sustained abnormal readings are observed associated directly with
physical activities or sweating.
● There are no special requirements regarding the maintenance of the transmitter ,charger and power adapter.
Clean them with alcohol pads if the surface becomes dirty. Dry completely before use.
● Charge your transmitter using Type-C USB cable and either the adapter included with your CT3 or any IEC 60601-
1 certified adapters.
● The CT3 rtCGM system contains no parts that require user repair. Please contact the manufacturer or your agent
for any problem. Do not open the device, replace or modify parts.
