6.3.2 Transmitting with Privacy Codes (TXCODE) --- MENU 02
You can configure different transmission Privacy Codes for each channel. The selected Privacy Code may be different for each
channel.
Note: Selecting a Privacy Code of "OFF" will disable the Privacy feature. To communicate between two P11UV radios, all
radios in your group must be set to the same channel and Privacy Code selections.
The transmission Privacy Codes setting steps are as follows:
1> Press
[MENU]
key to enter the main menu, and press
[+UP]/[-DOWN]
key to enter the MENU 02.
2> Press
[MENU]
key again to enter the
TXCODE
menu;
3> Press
[+UP]/[-DOWN]
key to select the Privacy Code, and the selection range is OFF / 67.0~754N.
Note: The state of the Privacy Code is off, and the display is OFF. When the display is OFF, press the [+UP] key to select
CTCSS with priority, range 67~254.1Hz (50 groups in total); when the display is OFF, press the [-DOWN] key to select DCS
with priority, range D754I-023N (104 groups in total).
During the selection process, Pressing and holding the [+UP] / [-DOWN] key to quickly search for the sub-tone code.
4> Press
[MENU]
key to confirm;
5> Press
[PTT]
or
[A/B]
key to exit the menu mode.
6.3.3 Squelch level (SQL) - MENU 03
This function turns on the Squelch when the signal is strong; the Squelch will stay off when the signal is weak. Set the same
DCS codes of your group and turn on the squelch.
By setting the level too high, you may not receive the weak signals; while by setting it too low you may receive noises or
undesired signals.
NOTE: This transceiver has 10 (0-9) available levels: 0 means that the Squelch is turned on. From level 1 to level 9 you will
have different levels of noises reduction.
The higher is the level, the louder will be the Squelch.
The steps for setting the squelch level are as follows:
1> Press
[MENU]
key to enter the main menu, and press
[+UP]/[-DOWN]
key to enter the MENU 03.
2> Press
[MENU]
key again to enter the
SQL
menu;
