20
21
Additional compass set-up information:
• If possible, select a level section of pavement, such as an empty parking lot or non-busy street,
to complete the compass set-up.
• Take a minimum of 20 seconds but less than 1 minute to drive in a circle during the set-up
process.
• If you take more than 1 minute to complete the circle, the radar detector will display
“PRESS ANY
BUTTON TO COMPLETE SET-UP”
.
•
Press any of the buttons
during the warning signal to complete the set-up.
• If you leave the radar detector untouched during this warning signal, it will display
“SET-UP
INCOMPLETE… PRESS MUTE TO RESTART SET-UP… PRESS BACKLIGHT TO CANCEL SET-UP”.
You can immediately restart the compass set-up by pressing the MUTE button or cancel the
set-up by pressing the BACKLIGHT button or by not pressing any of the buttons.
Using the Backlight
Press the BACKLIGHT button to switch the backlight on or off. The radar detector will sound 1 beep
when the backlight is turned on, and 2 beeps when it is turned off.
If the backlight stays on for more than 15 minutes, the screen will scroll twice ”BACKLIGHT IS
ON… TURNING OFF WILL PROLONG YOUR BATTERY LIFE”. This will repeat every 15 minutes.
The backlight is automatically on for 5 to 20 seconds at the following events:
• While the auto power-off messages are displayed – 20 seconds
• While the tutorial messages are displayed – 15 seconds
• While the low battery message is displayed – 10 seconds
• When a button is pressed – 5 seconds
• When an alert message is displayed – 5 seconds
OPERATION DETAILS
Summary of Contents for SENSORO SILVER BULLET RX7600
Page 30: ...NOTES...
