2. open the back cover of detector and put the wire
into the hole
2. Install the bracket at the right location (recommend 2.2m )
3. connect the terminal blocks (wiring diagram A)
Take out the detector and install it into the bracket accordingly,
adjust the angle.
4. cover the detection front cover
+12V:
positive pole of power supply /
GND:
negative pole of power supply
5. select the appropriate height of installation (recommend 2.2m )
ALARM:
output port of alarm /
TAMPER:
output port of anti-tamper
Installation Notice:
Please refer the content as follow before installation
1. Should install in the place which is most likely to illegal invasion.
2. Avoid the detector in the cold, heat exit.
3. Avoid the installing in sunlight or strong electromagnetic interference
4. Avoid larger air flow in detection area.
5. Avoid blind spots in protected areas,
Product use
1. Plug in 12V DC power, and red indicative light is on, detector enters the self-checking states. After 60 seconds,
indicative light is off, and the detector enter monitoring state
2. Sensitivity adjusting(P.COUNT): 1&2 is high sensitivity for the normal environment, 2&3 is low sensitivity for
the interference environment
3. Selection of output relay(RELAY): 1&2 is NC ,2&3 is NO
4. Selection of LED switch (LED ON) : insert Mini Jumper, the light is turned on, without Mini Jumper, light is off
Detection range of side view Detection range of top view
Notes:
1. Please install according to the manual and don’t touch the surface of sensor to avoid influencing on the
sensitivity. Please break the power and use a soft cloth with a little alcohol to clear.
2. The PIR detector distance will be influenced by the temperature, please should be avoided in places with
large temperature differences
3. Anti-theft products can increase the safety factor, but not guarantee to be absolutely safe. For your safety, in
addition to the proper use of this product, you also should be vigilant in daily life, strengthen the awareness of
security.
Senzor de miscare PIR cu cablu PNI SafeHouse HS130 pentru sisteme de
alarma
Senzorul cu fir PNI SafeHouse HS130 este echipat cu senzor infrarosu pasiv cu unghi larg, un design rafinat, o
instalare usoara, ce poate fi instalat pe tavan sau pe perete. Echipat cu senzor infrarosu de varf, tehnologie chip
SMT, design anti-EMI si anti-RFI, compensare temperatura si comutator LED, produsul are functii selectabile si
poate fi integrat/adaugat la un sistem de alarma cu cablu in aplicatii rezidentiale sau industriale.
Functii
1. Tehnologie MCU pentru a preveni tot felul de alarme false
5. LED ON/OFF optional, camuflare imbunatatita
