Plymovent MDB-DILUTER PRO, Installation And User Manual

Page: 13 / 34

0000300349/230420/0 MDB-Diluter PRO 12
4.8 Filter cartridges
To install the filter cartridges, do the following.
Fig. 4.25
• Loosen the star knob (F) and disassemble the cover plate
(E), the nut (D) and the metal washer (C).
• Put the filter cartridge (B) on the cartridge holder (A).
• Install the removed parts in reverse order.
Fig. 4.25
A B
D C E F
Installation of the filter cartridges
ATTENTION
Make sure that the front of the filter cartridge
aligns
*)
with the filter housing, so that the lid closes
well. If this is not the case, the filter cartridge is not
positioned correctly. This can cause leakage and less
efficient operation of the filter cartridge.
*)
tolerance: max. 2 mm (0.1 in.)
>2 mm
max. 2 mm
>2 mm
max. 2 mm
>2 mm
max. 2 mm
>2 mm
max. 2 mm
• Do the same procedure for the remaining filter
cartridge(s).
4.9 Dustbin
Fig. 4.26
• Put the dustbin (D) below the hopper (A).
• Use the handle (C) to lift the dustbin and put it in the right
position.
• Attach the dustbin to the hopper with the quick connect
clamp (B).
Fig. 4.26
A
B
C
D
Dustbin
4.9.1 Extraction fan
Fig. 4.27
• Put the extraction fan on the fan frame.
Fig. 4.27
A
B
Fan on frame
In the standard configuration, the inspection cover is located
on the front side. It is possible to change the inspection cover
to the rear.
• If desired/necessary, change the position of the inspection
cover.
4.9.2 Connection of the filter system to the fan
The outlet of the filter system is fitted with a connection ring.
Other necessary parts:
- adapter Ø 400 mm (15.7 in.)
- duct connector Ø 400 mm (15.7 in.) with KEN-LOK sealing
Fig. 4.28
• Put the adapter (B) on the connection ring (A). Do not slide
the adapter all the way over the ring, but leave approx. 20
mm (1 in.).
Disassemble the connection ring from the filter
system to facilitate assembly. Use a cordless drill
with a long pin to reinstall.
• Attach the adapter to the connection ring with 4 self-
tapping screws.
• Make this assembly airtight with duct tape (preferably two
laps).
• Install the duct connector (C) to the adapter (B). Attach it
with 4 self-tapping screws.