3. Install the new pad module by inserting the tabs on the module onto their slots
on the scanner.
4. Close the ADF cover by pushing it back down until it snaps back into place.
C
ALIBRATING THE
S
CANNER
Attention
Please uninstall the extended paper width sliders before
you start the calibration.
Calibrate the scanner if colors appear in areas that should be white, or colors of
the scanned image and the original vary a lot. This allows you to adjust and
compensate for variations that can occur in the optical component over time by its
nature.
The following describes how to calibrate the scanner:
1. The Calibration Sheet, marked with an arrow on either edge at both sides, is
used specially for
ADF Scanning
calibration.
2. Insert the special calibration sheet into the ADF of the scanner, with an arrow
toward the scanner buttons.
32
Summary of Contents for SMARTOFFICE PS282
Page 1: ...Installation Usage Maintenance ...
Page 4: ...CONTACTING PLUSTEK 40 ...
