E-6
CAUTION
• To prevent accidental injury due to the
main unit dropping or tipping over, the
main unit should be held by at least two
persons when mounting it on the stand.
• Check that the stand's hooks are
securely inserted into the main unit's
mounting holes. If not, the main unit
could drop, resulting in injury and
damaging the equipment.
• Make sure the locking knobs are
tightened when moving. If not, the
side bar's mounts could be bent or
otherwise damaged.
4. Assembly of the Stand
E-6
Locking knobs
2
Back (short)
Front (long)
The rear frame
Mounting
hole
Hook
1
2.
Attach the stabilizers to the front and back of the T-shaped feet.
CAUTION
• To prevent toppling, be sure to install the stabilizers at each
of the 4 locations. The toppling of this machine could cause
bodily injury or damage the machine.
Alignment of the screw holes of the T-shape feet with
those of the stabilizers.
Slide the stabilizers on the T-shaped feet to align with the holes.
CAUTION
• Do not lift the stand to work on it. This may lead to toppling
or bodily injury.
Secure the stabilizers on the T-shape feet by hexagonal
screws using hexagonal wrench.
Attach the 4 stabilizers on the feet.
T-shape foot
Stabilizer
Hexagonal wrench
Hexagonal socket screws
(M5 x 8mm)
3
. Mount the main unit on the stand.
The shorter side of the T-shaped foot is the back of the
stand. The diagrams show the procedure from the back
side.
Place the stand's hooks in the mounting holes in the
main unit's support pieces and insert securely in the
hook grooves.
Holes are located in three positions. The
mounted height can be adjusted in three
steps of 100 mm (1747, 1847 or 1947 mm
(maximum height)) according to which holes
are used.
Fasten the main unit with the locking knobs
(left and right).
