Plus BF-030PC, Setup Manual

Page: 8 / 16

8
2 HARDWARE SETUP
2.1 Setting Up the Copyboard BF-030PC
(1) Make sure the power to the personal computer and Copyboard are switched off.
(2) Use the interface cable provided and connect the connector at the bottom of the
Copyboard to the serial port (DB9F (9 pins) COM 1 or COM 2 Port) on the
appropriate type of personal computer. *1
A noise suppressing ferrite core (A) is provided at one end of the cable. Make sure
that this end is connected to the Copyboard connector.
(3) Switch the power on. Preparations are completed when the fluorescent lamp lights up
after about 4 sec.
(4) Start up the personal computer.
Personal Computer
INTERFACE CABLE
(A)
PLUS COPYBOARD
BF‑030PC
Fig. 2.1
*1 If the COM Port on the PC is not DB9F but DB25F (25 pins), an interchangeable
DB9F/DB25F connector can be purchased as an option.