15
If there is no input signal or no detected signal, the menu might not be displayed.
If you set the menu with an unstable signal status, it may cause an error.
The MENU setting values depend on the input signal mode. Therefore, please check the
input mode at the bottom of the menu when changing settings.
When Loop terminal is not used, select Analog Loop ‘No’
6. Control and Use of OSD Menu
• Brightness:
Adjusts brightness
• Contrast:
Adjusts contrast
• Chroma:
Adjusts chroma
• Phase:
Adjusts phase
• Sharpness:
Adjusts sharpness (This function can be
controlled by VR control Knob on the front panel.)
Note: In PC-RGB Input Mode,
• RGB Color Set:
Controls RGB Level in YPbPr,RGB,PC-
RGB input mode. Select Default or User Adjust
• NTSC Setup:
Select 0 IRE or 7.5 IRE. 7.5 IRE is used in
NTSC or YUV mode.
• Analog Loop (Option):
This function is only available
on products with the Loop Terminal. Set up On/Off
impedance of Analog Loop output terminals. Yes ->using
Loop output. No -> Not using Loop output.
6-1. Video Setup
1.
Press “MENU” button for OSD Display .
2.
Press “ENTER” button after menu selection by using UP ( ) / DOWN ( ) buttons.
3.
Adjust status on the selected item with ENTER and UP ( ) / DOWN ( ) buttons.
4.
Move to previous menu by using MENU button;
5.
Close the OSD screen by holding MENU continuously.