Plum eSTER x80, Installation And Operating Manual, Page: 9 / 20

9
Programmed schedule operates on
the basis of internal memory of the
wireless room panel and is not
deleted in absence of power supply.
8.11.10 Date
Setting the current date. After the date is
set, day of the week will be set
automatically. Synchronization function is
also applied here and it works similarly as in
case of changing time settings.
8.11.11 Panel
Enables assigning an individual address and
name to the wireless room panel.
 Panel address – user can select addresses
1, 2 or 3. This parameter enables
changing address of the wireless room
panel If several room panels are
connected to one main controller.
In order for the system to operate
correctly, particular room panels
must
be assigned different
addresses.
 Name – user can enter their own name of
the wireless room panel, e.g. attic, living
room, etc. It facilitates determining
location of the room panel inside the
building and changing preset temperature
in a distant room. This name will be
additionally visible on screens of other
room panels.
Selected panel Address (at 2 or 3 connected
panels) is displayed on the main screen as
(further digits 2, 3). Name is displayed
(also for other panels) in the upper bar of the
screen (on the left).
8.11.12 Radio module
Allows to perform the pairing of the wireless
room panel with the radio module. After
connecting the radio module to the main
controller, set the Pairing mode parameter to
Yes, which will start the wireless room
panel's pairing function with the radio
module for 4 minutes. The correct pairing will
be confirmed by a message on the screen of
the wireless room panel.
8.11.13 Information
The Information menu displays the strength
of the radio signal and information about the
software version of the wireless room panels,
the main controller and additional modules.
It is recommended to use the same
software version for all connected
wireless room panels.
9. Installation of the wireless room
panel
In order to ensure maximum effective
operation, please observe the following
recommendations regarding the place of
installation of the wireless room panel.
Recommendations:
 Wireless room panel is intended for wall
installation inside rooms,
 avoid highly insolated areas with poor air
circulation, near heating devices and in
direct vicinity of doors and windows –
temperature measurement is disturbed
by external conditions,
 assemble the wireless room panel at a
height of approx. 1.5 m above the floor.
The wireless room panel should be installed
in accordance with the following guidelines:
 drill holes in the wall (apply wall plugs in
case of masonry wall) and screw the
screws in. Distance between holes is
given on the housing back side of the
wireless room panel (90 x 43 mm),
 execute electrical connection (only power
supply) between the wireless room panel
and the main controller or additional
power supply serving as its power source
with the use of electrical wire. Wire can
be flush or wall mounted.
Do not lead the connection wire
along with wires of electrical
network in the building. Wire
cannot be located near devices
emitting strong electromagnetic
field.