OCP (SMD) Build guide (v1.0), 04/07/2022
5
Teensy 3.2
Inside the kit you will find the teensy board and rows of 14,
13 and 2 pin headers, the male headers is already attached
to the female sockets (If not, please connect them before
soldering).
The side of female sockets should soldered to the back of
the module board and the pin headers to the teensy board.
Insert all sockets to the holes in the module board, place the
teensy on top of the pin headers and first solder the pins to
the teensy.
then you can solder the female headers to the main board
from the other side.
(Video of the TH version assembly, it’s exactly
the same here…)
6
Pogo Pins
used to connect 3 pads from the bottom of the teensy board
to the module board.
one pin is for reset and other two is to connect the USB data
signals (D+ and D-).
first you need to remove the teensy from his socket.
Insert the pins to the holes (spring end should face up) and
solder them from the other side of the board.
FRONT SIDE OF THE BOARD (INTERFACE PARTS):
1. OLED SCREEN
Inside the kit you will find a small bag with the OLED, 3 standoffs and 1X7 pin header.
First screw the 3 standoffs to the board in order to support the screen, insert 1X7 pin headers to
the holes in the module board.
Place the screen on top of the standoffs, make sure that the pin headers in their places from
both sides and tight the top 2 screws. now you can solder the pin headers from both sides.
(Video of the TH version assembly, it’s exactly the same here…)
