OCP (SMD) Build guide (v1.0), 04/07/2022
BACK SIDE OF THE BOARD:
All the SMD components are already pre-soldered but few TH parts should be soldered here:
The parts are ordered according to their height on the board and I recommend assembling them
in this order.
1
VOR Pin headers
(1 Row of 3 Pins) for VOR Select jumper.
After soldering - Use the jumper cap to select the desired
option.
The position of the jumper is used to set or disable the VOR
option of the hardware.
See further explanation later in this document
2
Back TRIG Pin headers
(1 Row of 4 Pins) For back
TRIG_IN Interface.
These headers are connected to the normalization pin of the
trigger inputs and allow a 1uT_u (1U Temps Utile)
connection in favor of receiving triggers from the back (or
connection to the trigger pin of the bus board if you have
supporting modules
3
Power connector
–
Power ribbon cable should connect your
bus board to this connector.
pay attention
– the “cut” in the plastic shield should oriented
as printed on board.
4
R785.0-0.5
, 5V DC-DC Converter (Regulator)
