18
PLINIUS TOKO
Troubleshooting
NO SOUND FROM THE UNIT
If the unit is not reproducing audio take the following steps:
•
Check the Toko is correctly connected to an appropriate input on the preamplifier.
Refer to the Installation & Operation section.
•
Check the preamplifier is set to select the correct source input. Adjust the source
selector for the Toko as the source component.
•
Check the volume. Turn the volume up to a point just below the normal listening
level. DO NOT turn the volume up to maximum in case the sound begins to come
through the speakers.
•
Check the system is working with another source to confirm the fault is not due
to the preamplifier or power amplifier stages.
•
Check the Toko is working with a CD to confirm the fault is not due to the Media
Server or Network components.
NETWORK STREAM PLAYBACK OR DEVICE CONNECTIVITY PROBLEMS
•
Check the Network components are working correctly. Ensure the Music Service
is active and the control device has recognised the Toko as the Renderer and
has recognised the Media Server Library device also.
•
Check the Network connections are active. Check the router is operating
correctly and any wireless connections have a strong signal. Try other network
connected devices to confirm connectivity across the network is active.
NO TRACK DISPLAY LEDS
•
Check a valid CD is in the transport. If the CD cannot be read, the Toko will not
show any track information.
•
Adjust the display brightness through the levels high, low and off in case the
display has gone into standby mode.
POWER FAILURE
The unit may have suffered mains fuse failure. Check the mains fuse and replace if
needed. NOTE: If the unit immediately or repeatedly suffers mains fuse failure, there
may be a major problem and you should contact your Plinius dealer.
