7
INTEGRATED AMPLIFIER
Front Panel Functions
The front of the Plinius Hiato Integrated Amplifier incorporates all the facilities you will
require on a daily basis.
1. DISPLAY LED
An LED on the front panel indicates that the power is on. When first switched on the
unit will go into standby and the display LED will vary in brightness. When the unit is
taken out of standby and is ready for use, the LED will remain lit. Whenever mute or a
remote volume button is pressed, the LED will dim.
2. SOURCE DISPLAY LEDS
These small white LEDs communicate the current source selection.
3. SOURCE SELECTION BUTTONS
The buttons on the front panel allow selection of any of the different inputs available
on the rear or front panel. This selection is fed to the pre out, line out and speakers
outputs of the amplifier. NOTE: Phono button and LED are only present on units that
have the phono option installed.
4. AUX INPUT
The AUX (Auxiliary) input is a 3.5mm stereo jack that allows instant connection to
portable media devices or laptop computer outputs via a standard 3.5mm jack cable.
NOTE: Line out from the device is preferred. If line out is not available, adjust device
volume to approximately 75% to avoid overdriving the Hiato input.
5. PHASE DISPLAY LED
This small white LED is ON when the phase of the input signal to the amplifier is
inverted 180 degrees. This option is selected using the remote control.
1
3
4
5
6
7
2
