16
PLINIUS HIATO
over tighten. If bare wires are used make sure that no loose strands of wire short
across the other terminals or the amplifier chassis. When using plugs such as
bananas, be sure to use good quality plugs with a firm fit.
BI-WIRING
Bi-wiring uses two pairs of loudspeaker cables for each channel loudspeaker. You will
notice that the rear panel of your Plinius Hiato has two pairs of output terminals for
this purpose. When using bi-wires, always connect positive (+) to positive (+) and the
same for the negative (-) terminals.
PHASING (OR POLARITY)
It is important to achieve good stereo imaging in your listening room. By observing
the wiring instructions above, each power amplifier/loudspeaker combination should
be in phase. If you experience poor stereo image and/or a lack of bass, check that
the loudspeaker wiring has been connected correctly. We recommend that you use
one of the easily obtainable ‘test discs’ to help you ensure both phasing and channel
orientation are correct. If in doubt, consult your Plinius dealer for advice.
Naturally it is also important to make sure all the leads carrying signals for the RIGHT
channel loudspeaker are connected to the RIGHT input to the amplifier from your
preamplifier or CD player etc. Signals for the LEFT channel should be wired in a
similar fashion.
USING HT BYPASS INPUT
The Hiato Integrated Amplifier features a home theatre input to bypass the
preamplifier stage when used in home theatre or multimedia installations. When HT
Bypass is selected on the Hiato, the signal will pass from the HT Bypass input directly
to the Hiato power amplifiers.
This enables the unit to remain in circuit for use with two channel sources (such as
CD players and tuners), as well as a link to the speakers should you wish to use your
normal stereo set-up in a surround or home theatre environment.
To access the HT Bypass input, press the HT button on the remote control. To exit the
HT Bypass mode and return to using a source component, press HT again, or use the
source buttons to scroll to any desired source component.
NOTE: Only connect a suitable pre out signal to the HT Bypass input. When HT Bypass
is selected, no volume or phase settings can be accessed. A signal connected to the
HT Bypass input will also go to BOTH the RCA and XLR pre out connectors.
USING PRE OUT
A preamplifier output is provided on the back of the Plinius Hiato. If you wish to use
the Plinius Hiato as a pre-amp only, or to send signal to another amplifier, fit the
