Plextor PX-504UF, Installation And User Manual

Page: 28 / 64

Section 2. Installing Your PX-504UF
20
Plextor PX-504UF Installation and Users Manual
6. If the USB or IEEE 1394 controller is listed and does not have a
yellow diamond with an exclamation point, but the Plextor drive is
listed as a “USB” or “IEEE 1394 Storage device”, select the
“Storage device” and then select the “Remove” button. Reboot your
system. The system will do another hardware scan and should install
the driver properly.
Switching Between USB and IEEE 1394
Interfaces
You can connect any or all of the interface cables (USB, IEEE 1394 4-
pin, and IEEE 1394 6-pin) and switch between them. You can even have
different cables attached to different computers.
To switch between interfaces attached to the PX-504UF:
1. Ensure the interface cable for the desired USB or IEEE 1394
interface is attached to the PX-504UF and to the computer.
2. At the rear of the PX-504UF, set the interface switch to the desired
interface.
3. Cycle the PX-504UF power. (That is, turn the PX-504UF’s POWER
switch off, then on again.)