PlexWriter 8/4/32 Operation Manual
29
5. Maintenance and Troubleshooting
This chapter explains maintenance and troubleshooting procedures for your
PlexWriter drive.
With proper maintenance, you can prevent problems. If problems arise, you can
often solve many simple problems on your own, rather than wait for assistance from
a Plextor representative.
TIP
: Read all of this section that pertain to you (PC or Macintosh). Many of the
problems discussed happen only rarely, and others may seem as if they do not
pertain to you. However, if you are familiar with the variety of problems that can
occur, you will be better prepared to deal with them if they do occur.
Upgrading Firmware
Plextor creates firmware revisions to meet the peculiar needs of large computer
manufacturers. It is rare that these will impact the performance or operation of your
PlexWriter drive. However, we advise that our customers always update drives with
latest available firmware. Before troubleshooting a possible problem with your drive
please make sure to visit our web site at
www.plextor.com
to check if you have the
latest firmware.
To obtain new firmware for your PlexWriter drive:
1.
Go to the Plextor web site at
www.plextor.com
.
2.
Look for firmware upgrades in either the Technical Support area or on the
Downloads page. There is a description of the latest firmware revision and its
intended use.
3.
Download the firmware to your computer.
To upgrade firmware:
1.
Run the executable file that you downloaded from Plextor’s web site.
2.
Accept all defaults by continuing to click on the “Next” button until you see the
message:
Firmware update has completed.
3.
Reboot your system.
4.
Verify DMA is enabled before using the PlexWriter
Note:
If firmware upgrade does not complete successfully, you may need to disable
DMA and this procedure again.
To enable/disable DMA:
1.
Click the Start button, then Settings, then Control Panel, then double-click on
System icon, then select the Device Manager tab. You see a list of devices in
your system.
