Section 2. Installing Your PlexWriter
PlexWriter 40/12/40S Installation and Users Manual
23
9. Connect the audio cable if you want to use a sound board in your system. This
cable runs from the four-pin AUDIO OUT connector on the rear panel of your
PlexWriter drive to your sound board. See page 27 for more information about
audio cables.
10. Connect the SPDIF cable if your sound board is equipped with SPDIF and you
wish to use the SPDIF digital audio output from your PlexWriter. This cable runs
from the right-most set of pins on the jumper panel to the sound board.
Figure 15 shows how the optional SPDIF cable is connected to the jumper panel.
(The SPDIF cable is not supplied by Plextor.)
Figure 15: Installing the Optional SPDIF Cable
11. Before completing the installation, check your cable connections against
Figure 16.
