20
Note: Other cylinders may be acceptable for use with this appliance provided they have the same
profile and dimensions to be compatible with the appliance nesting hole and retention means.
Before Turning Gas Supply ON:
1. Your fire pit was designed and approved for outdoor use only. Do NOT use it inside a building,
garage, or any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and other flammable
vapors or liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and
there are no leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed during
assembly or servicing is replaced and fastened prior to starting.
Caution: Do not attempt to operate until you have read and understand all General Safety
Information in this manual and all assembly is complete and leak checks have been performed.
Figure a
Figure b
Figure c
in.
in.
in.
in.
in.
in.
Normal
Abnormal
Figure a
Figure b
Figure c
in.
in.
in.
in.
in.
in.
Normal
Abnormal
Figure a
Figure b
Figure c
in.
in.
in.
in.
in.
in.
Normal
Abnormal
Figure A
Figure B
Figure C
OPERATION INSTRUCTIONS
Before Lighting:
1. Fire pit should be thoroughly inspected before each use, and by a qualified service person at
least annually. If relighting a hot fire pit, always wait at least 5 minutes.
2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas
should be leak tested. If the hose leaks, it must be replaced prior to operation. Only use the
replacement hose assembly specified by manufacturer.
Lighting:
1. Turn the control knob to the “OFF” (
Figure a
Figure b
Figure c
in.
in.
in.
in.
in.
in.
Normal
Abnormal
) position (Figure A).
2. Fully open LP cylinder valve.
3. Push in gas control knob and turn counterclockwise to “IGNITER” ( ) (Figure B) to light the fire
pit.
If needed, keep depressing and turning control knob counterclockwise until the fire pit lights
(You should hear a clicking sound).
4. After the fire pit lights, release the control knob. Push in and turn the control knob to the
“HIGH” (
Figure a
Figure b
Figure c
in.
in.
in.
in.
in.
in.
Normal
Abnormal
) (Figure C), then release the control knob. If you want a lower temperature, push in
the control knob and turn counterclockwise to the “LOW” (
Figure a
Figure b
Figure c
in.
in.
in.
in.
in.
in.
Normal
Abnormal
).
Note:
If burner fails to remain lit, all valves should be closed and a waiting period of at least
5 minutes should pass before attempting to light.
WARNING
Lighting operations should comply with Lighting Instructions section. Improper lighting operations
will cause serious injury and explosion.
