Questions, problems, missing parts? Before returning to your retailer, call our
customer service department at 877-447-4768 8:30 a.m. - 4:30 p.m. CST,
Monday - Friday or e-mail us at [email protected].
5/2/2018
60-10-002
SAFETY NOTICE: IF THIS WOOD BURNING APPLIANCE IS NOT PROPERLY INSTALLED,
OPERATED, AND MAINTAINED, A HOUSE FIRE MAY RESULT.
TO REDUCE THE RISK OF FIRE, FOLLOW THE INSTALLATION INSTRUCTIONS. FAILURE
TO FOLLOW THE INSTALLATION INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE,
BODILY INJURY OR EVEN DEATH. CONTACT LOCAL BUILDING OFFICIALS ABOUT
RESTRICTIONS AND INSTALLATION INSPECTION REQUIREMENTS IN YOUR AREA.
This manual describes the installation and operation of the model series HWS-224172MH and HWS-
224172MH-B wood heaters. This heater meets the 2015 U.S. Environmental Protection Agency’s crib
wood emission limits for wood heaters sold after May 15, 2015 with an emission-rate of 3.9 g/hr. Under
specific test conditions this heater has been shown to deliver heat at rates up to 50,000 Btu/hr. This wood
heater needs periodic inspection and repair for proper operation. It is against federal regulations to oper-
ate this wood heater in a manner inconsistent with operating instructions in this manual. Please read this
entire manual before you install and use your new room heater. Failure to follow instructions may result in
property damage, bodily injury, or even death.
This stove is listed by OMNI-Test Laboratories
of Portland, Oregon to meet UL1482 for the US
and ULC-S627 for Canada. (UM) 84 HUD, mobile
home approved (Excluding model WS-2417).
6” Flue
required
Do Not Discard This Manual: Retain for Future Use
Save These Instructions
Wa r m i n g Yo u r H o m e. W a r m i n g Y o u r H e a r t.
High Efficiency Wood Stove - Small
Model Series:
HWS-224172MH
HWS-224172MH-B
(Mobile Home Approved)
TESTED TO: UL 1482-2011/ULC-S627-00
ASTM E2780, EPA Method 28R
REPORT NO. 0418WS014S/0418WS014E
6440 W. Howard St.
Niles, IL 60714-3302
877-447-4768
BEFORE LIGHTING YOUR FIRST FIRE, REMOVE PLASTIC FILM OFF TRIM AND CLEAN THE
PLATED SURFACES WITH DENATURED ALCOHOL OR A GOOD QUALITY, NON-ABRASIVE LIQUID
GLASS CLEANER. APPLY WITH A VERY SOFT, CLEAN CLOTH. DO NOT USE PAPER TOWELS
TO CLEAN THE PLATED PARTS. FAILURE TO CLEAN ALL MARKS AND FINGERPRINTS FROM
THE PLATED SURFACES WILL CAUSE PERMANENT DAMAGE.
NOTE: Some states and provinces do not allow the exclusion or limitation of incidental or consequen-
tial damages. The above limitations may not apply to you.
WARNING
Español p. 21
Français p. 43