Model XX0596
ECN2463
Page 11 of 14
Installation Instructions
Attach the spring cover panels to the spring mounting plate.
__Step 11:
Attach the spring cover panels to the spring mounting plate. See
Detail G
. Select both cover panels and the appropriate hardware. There are (2)
two connections. Place the cover panels on top of the spring mounting plate and
make attachments as shown. Fully tighten connections.
Attach the cover panel to the frame
.
__Step 12:
Attach the cover panel to the frame. See
Detail H
. Select the see-saw
cover panel and the appropriate hardware. There are (4) four connections. Place
the cover panel, with the countersunk holes facing up, on top of the mounting
brackets on the see-saw frame and make attachments as shown.
Attach the seat mounting brackets to the frame.
__Step 13:
Attach the seat mounting brackets to the frame. See
Detail I
.
Select the (4) four seat mounting brackets, (4) four pieces of plastic trim and
appropriate hardware. There are (12) twelve lower connections and (8) eight
upper connections. Position a bracket and a piece of plastic trim against each
end of the see-saw frame and, using loctite on the 1" bolt threads only, make
attachments as shown.
Note
: Two of the mounting brackets and plastic trim are designed to be mounted
on the left side of the see-saw frame and two on the right side. Hole patterns are
distinct and brackets can only be mounted on the correct side.
Attach the side panels to the frame.
__Step 14:
Attach the side panels to the frame. See
Detail J
. Select (4) four
handle side panels and appropriate hardware. There are (8) eight connections.
Position each side panel against the see-saw frame just ahead of each seat
mounting bracket and, using loctite on the bolt threads, make attachments as
shown. Leave connections loose.
Note
: Ensure the side panels angle towards the seat mounting bracket.
Attach the handles to the side panels.
__Step 15:
Attach the handles to the side panels. See
Detail K
. Select (4) four
handles and the appropriate hardware. There are (16) sixteen connections.
Position each handle between the top or bottom of each pair of side panels and
make attachments as shown.
Attach the seat covers to the bottom of the seat mounting bracket.
__Step 16:
Attach the seat covers to the bottom of the seat mounting bracket. See
Detail L
. Select (2) two seat covers and the appropriate hardware. There are (8)
eight connections. Position each seat cover, with the countersunk holes up, over
the bottom of the seat mounting brackets and make attachments as shown.
Attach the seat covers to the top of the seat back.
__Step 17:
Attach seat covers to the top of the seat back. See
Detail M
. Select
(2) two seat covers and the appropriate hardware. There are (8) eight connections.
Position each seat cover, with countersunk holes out, against the seat backs and
make attachments as shown.
Final Details.
__Step 18:
Plumb and level the entire component. Tighten
all
fasteners. Fully
tighten all fasteners according to tightening torque specifi cations. Block and brace
for concrete. Pour concrete after all equipment has been assembled. Allow 72
hours for concrete to completely cure.
Note
: Check for proper operation. Frame should pivot smoothly on the shaft.
__Step 19:
For areas complying with ASTM standard F1487 and CSA Z-614,
apply the age appropriate label at a visible location on the equipment. Also apply
the Surface Warning labels at the locations indicated on the
Elevation View
.
