PLAYSTAR Little Sprout Play House PS 7490 Safety Manual & Assembly Instructions Download Page 3

3

INSTALLATION:

1.  Follow the instructions provided, do not  
 

alter its design in any way.

2.  Place the equipment on level ground,  
 

not less than 6' (1.8m) from any structure  

 

or obstruction such as a fence, garage,  

 

house, overhanging branches, laundry  

 

lines or electrical wires. If the area  

 

where you will be installing your play- 

 

set is not level, you must make it level.

3.  Playsets must be anchored to the  
 

ground. Follow the anchoring instruc- 

 

tions provided with your building kit. If  

 

soil conditions permit anchors to be  

 

pulled out easily, such as in sandy soil  

 

conditions, cementing is required.

4.  Tighten all bolts securely to the intended  
 

member then cut off all protruding  

 

threaded ends of bolts with a hack saw  

 

flush to the end of the nut and  

 

remove sharp edges with a metal file.

WARNING: Children must not use the  
playset until properly installed and proper 
shock-absorbing surfacing material is in place.

OPERATION:

   Observing and  

following statements and  warnings 
reduces the likelihood of serious or 
fatal injury.
 
1.  On-site adult supervision is recommended 
for children of all ages.

2.  Only one child, for each single planned  
 

seat or single planned activity should  

 

be allowed on this set at one time, with  

 

a maximum weight of 

105 pounds for  

 

each child

. 

WARNING:  You must teach children the 
following:    
A. 

Not to walk close to, in front of, behind,  

 

or between moving items.

B. 

Not to twist swing chains or ropes or loop  

 

them over the top support bar since this may  

 

reduce the strength of the chain or rope.

C. 

Avoid swinging empty seats.

D. 

To Sit in the center of the swings with  

 

their full weight on the seats.

E. 

Not to use the equipment in a manner  

 

other than intended.

F. 

Not to get off equipment while it is in motion.

G. 

Not to climb when equipment is wet.

H. 

Not to attach items to the playground  

 

equipment that are not specifically  

 

designed for use with the equipment  

 

such as, but not limited to, jump  

 

ropes, clothesline, pet leashes, cables  

 

and chain as they may cause a  

 

strangulation hazard.

I. 

Remove bike or other sports helmet  

 

before playing on the playground   

 equipment.
3.  Verify that suspended climbing ropes  
 

are secured at both ends and that they  

 

cannot be looped back on themselves.  

4.  Dress children appropriately and do not 
 

allow them to wear inappropriate items, 

 

such as but not limited to, loose fitting 

 

clothing, hood and neck draw strings,  

 

scarves, cord-connected items, capes,  

 

and ponchos.  These items can cause  

 

death by strangulation. Provide well- 

 

fitting and full enclosure footwear.   

 

Examples of inappropriate footwear 

 

are clogs, flip flops, and sandals. 

5.  Verify that all suspended swinging  
 

components have at least 8" clear- 

 

ance between the lowest point of  

 

component and top of shock-absorbing  

 

surfacing material.

WARNING:  Lawn swings are designed 
for use by children two years of age and 
older. Use by children under the age of 
two can result in entrapment between the 
seat and backrest. 

NEVER place children 

in a rearward facing position or with legs 
between the seat and backrest because 
the child’s body may pass through the 
opening causing entrapment of the child’s 
head. 

DISPOSAL:

When the playset is to be retired from 
service, disassemble and dispose of in 
such a way that no unreasonable hazards 
will exist. Follow your local disposal 
requirements.

At the beginning of play season:     Date: ___________

  n

 Tighten all hardware.

  n

 Lubricate all metallic moving parts per  

    manufacturer’s instructions.

  n

 Check all protective coverings on bolts, pipes, edges,  

   and corners. Replace if they are loose, cracked, or missing.

  n

 Check all moving parts including swing seats, ropes,  

    cables, and chains for wear, rust, or other  
    deterioration. Replace as needed.

  n

 Check metal parts for rust. If found, sand and repaint  

    using a nonlead-based paint meeting the  
    requirements of 16 CRF 1303.

  n

 Check all wood members for deterioration and  

    splinters. Sand down splinters and replace  
    deteriorating wood members.

  n

 Reinstall any plastic parts, such as swing seats or  

   any other items that were removed for the cold season.

  n

 Rake and check depth of loose fill protective  

    surfacing materials to prevent compaction and to  
    maintain appropriate depth. Replace as necessary.

Twice a month during play season:  Date: _________

  n

 Tighten all hardware.

  n

 Check all protective coverings on bolts, pipes, edges,  

   and corners. Replace if they are loose, cracked, or missing.

  n

 Rake and check depth of loose fill protective  

    surfacing materials to prevent compaction and to  
    maintain appropriate depth. Replace as necessary.

Once a month during play season:  Date: _________

  n

 Lubricate all metallic moving parts per  

    manufacturer’s instructions.

  n

 Check all moving parts including swing seats, ropes,  

    cables, and chains for wear, rust, or other  
    deterioration. Replace as needed.

At the end of each play season or when the  
temperature drops below 0º F:
        Date: _________

  n

 Remove plastic swing seats and other items as specified  

    by the manufacturer and take indoors or do not use.

  n

 Rake and check depth of loose fill protective  

    surfacing materials to prevent compaction and to  
    maintain appropriate depth. Replace as necessary.

SAFETY

ANNUAL MAINTENANCE CHECKLIST 

(Copy this section as needed and maintain for your records or visit www.playstarinc.com/maintenance)

Owner shall be responsible for maintaining the legibility of any warning labels.

If any of these conditions exist, call 1-888-752-9782 for ordering information.

Clean plastic components with warm water and a mild detergent such as dish soap.

Summary of Contents for Little Sprout Play House PS 7490





























Reviews: