5-6 Agecroft Trading Estate, Langley Road, Salford Manchester M6 6JD
Tel:
+44 161 737 5099
Website
:
Help & Support:
Page
2
of
4
Instructions
Two competent adults are required to assemble this product.
1.
It is recommended to test the product to ensure it is fully working. Add 0.5lt - -1lt of water o the
acrylic tube by removing the lid and gently pouring water directly into the top of the Tube. Plug the
adapter in and turn the item on, ensuring the lights and remote is working, ensuring the pump is
heard. You should see a small amount of bubbles occurring in the bottom of the panel. Now empty
the water again by pouring out into a bowl, sink, bath or outside.
2.
Decide where you wish to place this product and stand in position.
3.
Once in position gently fill the acrylic tube with water
until the water level is approximately 1/2’’ from
the rim.
4.
Add the beads to the bubble tube
5.
Plug the adapter in the black jack/socket at the base and plug the other end into the wall socket.
6.
Using your remote to control the lights and mode
Remote Control Functions
To change the battery in the remote, please follow the instructions on the reverse of the remote.
Increase/decrease
brightness on static
colour mode
Play/pause any
dynamic colour
changing pattern
Turn on/off
Selections of colour
in static mode
Cycles through all
colours randomly
(speed can be adjusted)
Turns ON/OFF static
colour in strobe mode
(speed can be adjusted)
Trio or Seven colour instance
change (speed can be adjusted)
Trio or Seven colour fade
(speed can be adjusted)
Increase/decrease
speed on all dynamic
modes
