10
ENGLISH
Assemble the FPV holder and servo
Use two self-taping screws to tighten
the FPV pack
The following pieces need to be assembled. Put the servo horn fit inside the holder. Use a side cutter or
another sharp tool to cut the edges. Use caution when handling sharp tools.
Fasten the servo horn to the holder with self tapping screws until you feel it is secure. The picture above
is an example of how it can look. The next step is attaching the ultrasonic sensor to the holder. It's
recommended to use cable ties, rubber bands or thread/plastic strings (none included). The result should
look like the picture below.
